CRC Galva Brite Cold Galvanizing Spray

CRC Galva Brite Cold Galvanizing Spray forms a protective zinc-aluminium coating on the surfaces. It has corrosion protection properties. This spray is a combination of zinc and aluminium powders, resins and additives. A safety data sheet (MSDS) that is made as per EU directive 93/112 is available for all CRC products. When it comes to delivering spray, we use those shipment modes that enable us to deliver it on time.

Highlights :

  • Excellent touch-up for galvanized surfaces
  • Provides excellent corrosion and rust resistance to ferrous metals
  • The galvanic properties ensure cathodic protection (the coating becomes the anode).
  • Unique combination of flexibility and hardness
  • Resists rusting, peeling and fading
  • Adheres well to metal surfaces
  • Combines the galvanized look with the convenience of an aerosol application
  • Totally lead and chromate free
  • No chlorinated and low-aromatic solvents
  • Aerosols use dimethylether (DME) propellant for controlled spray and film properties

Applications :

  • Fences and gates Home
  • Garden and farm equipment
  • Construction equipment
  • Structural steel Guard rails
  • Welding seams Pipes and fittings
  • Coastal and ship borne installations
  • Repair of LPG storage tanks

Directions :

  • Shake aerosol can very well for at least one minute after agitator ball is free
  • Stir or mix bulk product well to obtain a homogeneous dispersion
  • Repeat frequently while using. Apply to a clean, degreased, dry surface for best results
  • Remove rust and scale with a wire brush
  • Apply in light, even coats; best results are obtained with 2 lighter rather than 1 heavy coat
  • Additional coats can be applied after 15-20 minutes
  • When spraying is finished, clean aerosol valve by turning can upside down and press button until only propellant escapes
  • If clogging occurs, remove button and clean orifice with fine wire
  • Do not use on energized equipment
  • Use in well-ventilated area

Specifications :

  • Appearance : bright aluminum finish
  • Resin type : modified alkyd
  • Pigment type : zinc, leafing aluminium
  • Specific gravity : 1.06
  • Flash point (solvents) aerosol : -40C
  • Coverage (30 um, dry) aerosol: approx. 1.6 m2/can (400 ml)
  • Drying times to touch : 10-15 min
  • Recommended film thickness : 30-40 um
  • Thinner / cleaner : white spirit, acetates Dry film properties (35 um on degreased metal)
  • Salt spray (ASTM B 117) : 100 h  (35 um film thickness)
  • Adhesion on steel (NFT 30038) : 0
  • Flexibility (6 mm mandrel, visual) : pass
  • Heat resistance (4 h @ 200 °C) : slight
  • Yellowing Hardness Persoz (after 72 h) : 80 s

Additional Information

Payment Terms Other